Hydrovane Compressors

Yes. Air-Mech has been an authorised Hydrovane distributor since 1980. We fit genuine parts, have access to factory technical support, and can offer full manufacturer warranty on all new Hydrovane installations.

A rotary vane compressor uses a sliding-vane design: a rotor with vanes that slide out against the housing to compress the air. It is single-stage with fewer moving parts than a rotary screw, which is why it runs quieter and delivers steadily under continuous load. Rotary screw generally suits higher flow demands. Which is right for you depends on your duty cycle and flow requirement.

The HV rotary vane range runs from 1.5 to 75 kW. Above that, or where flow demand is better matched by screw technology, we would typically specify from the HR series or the wider CompAir range.

Generally yes. The sliding-vane design has fewer moving parts and lower vibration, which is why Hydrovane units are often chosen for installations close to a working area or where noise is a constraint. If low noise is the priority, it is worth looking at our silent and low-noise range alongside Hydrovane.

Yes. We service all Hydrovane equipment regardless of where it was purchased. As an authorised distributor we use genuine parts and have factory technical support behind us.

No. Pricing depends on the model, configuration, ancillary equipment, and installation requirements. We provide a written quotation after understanding your compressed air demand and site conditions. All quotes include installation and commissioning.